As it arrived at the shop...nice looking bus!

Needs tune up and some other mechanical work

cleaning and inspecting air cleaner assembly. Breather hose was not connected properly...

interesting repair on air cleaner intake elbow. This should be replaced

general motor shot

big air gap where the rear apron tin has been cut at the fresh air hose inlet - will put a seal here to cut down on the hot air exchange.

carbon canister outlet needs a cap

there we go!

coil has slid down in bracket - will re-adjust

right rear brake drum was very lose on stub axle and has worn the drum face significantly - this will need replaced and torqued to spec.

damage to the inside surface of the drum

damage to the outside surface of the drum

source a good used rear drum. Turning it on the brake lathe...

gasket were glued to valve covers! What a pain...

rocker was missing spacer and spring washer, so it was moving back and forth along the shaft!

this amount of play will break a valve in the long run...

disassembled rockers to replace missing components

sourced another space and wave washer and installed them.

removing old fuel filter

new fuel filter installed, coil position adjusted, breather hose installed, and fresh are hose seals installed